Mossy Forest Floor Necklace

Materials:

• Peridot .019 Diameter Soft Flex® Beading Wire
• Non-Tarnish Silver 20-gauge Soft Flex® Craft Wire
• 24mm Sterling Silver Toggle Clasp - 1 clasp set
• 9x24mm Sterling Silver Cones - 2 cones
• 6mm Sterling Silver Heishi Spacers - 15 spacers
• 5mm Sterling Silver Soldered Jump Rings - 8 soldered jump rings
• 5mm Sterling Silver Open Jump Rings - 2 open jump rings
• 2mm x 2mm Sterling Silver Crimp Tubes - 2 crimps
• 5x6mm Bronze Drop Pearls - 1 strand pearls
• 12x22mm Moss Green Lucite beads - 8 Lucite bead

Tools:

• 4-Pin Knitting Spool with Stylus
• Cutters
• Crimping Pliers
• Chain Nose Pliers
• Round Nose Pliers
   

Instructions:

1. Use the Peridot wire (do not cut any wire from the spool) to string all the pearls. Use the wire and the Knitting Spool to knit a 4" length of knitted wire using Style 3 in the instructions for How to Use the Knitting Spool, making sure to leave a 3" tail of wire at the beginning of the wire and adding 1 pearl to each knitted stitch. Cut the wire from the spool, leaving a 3" tail. Set aside.
    
2. Use 2" of 20-gauge wire to form a wire wrapped loop. Use one end of the beading wire to string 1 crimp tube and the wrapped loop just formed. Pass back through the tube and crimp. Use the 20-gauge wire to string 1 cone (wide end first). Snug the cone onto the knitted wire and form a wire wrapped loop that attaches to 1 soldered jump ring. Repeat entire step for the other end of the knitted wire piece.
    
3. Use 4" of 20-gauge wire to form a wire wrapped loop that attaches to the previous jump ring. String 1 heishi spacer, 1 Lucite bead, and 1 heishi spacer; form a wire wrapped loop that attaches to 1 soldered jump ring.
   
4. Repeat Step 3 twice. Repeat Step 3, omitting the soldered jump ring. Use 1 open jump ring to attach the previous wire wrapped loop to one half of the clasp.
   
5. Repeat Steps 3 and 4 for the other half of the necklace.