Listful Leaves Sandals and Bracelet Pattern
From the Blogger: "This is a fun, versatile design! The Dorabeth Designs focal component, an open charm, is also fully reversible with a different but related design on the other side. You can make this piece in a myriad of colors; the focal also comes in antique silver for a different loop. This design can also be easily modified to make a footless sandal. Sizing is also easy with the wrapped bracelet. This can easily be made in under an hour."
Project TypeMake a Project
Bead TypeMetal, Miscellaneous
Time to CompleteUnder an hour
Bead Technique UsedStrung
Bead Project TypeBracelet
Materials List
- 54 inches 2mm Round Leather Cord - Turquoise
- Two Kazuri Round 10-12mm Mother of Pearl - Peacock
- One TierraCast Clasp Toggle Maker's - Silver Plated
- Two B&B Benbassat Cord Leather Flat End Cap Crimp 5mm Flower - Silver Plated
- 50 Pewter Bead Spacer Ring 2mm Plain - Antique Silver
- Two Jump Ring 6mm 21g - Silver
- Two Eye Pin 2 inch 20g - Silver
- 4 inches Wire - 24 Gauge - Non-Tarnish Silver
- Super New Glue®
Boho-Chic Listful Leaves Sandals Pattern
DIY Sandals Jewelry Pattern Instructions
-
Cut the leather into 23-inch, 27-inch, and 4-inch sections.
-
Fold the 4-inch section in half, apply a small amount of glue to the ends, insert into an end cap, and crimp closed.
-
Glue one end of the other two sections of leather into the second end cap and crimp closed.
-
String each Kazuri bead onto an eye pin and form a simple loop at the top. Use one Kazuri link to attach the Dorabeth link to one of the cord ends; repeat with second link.
-
String 25 pewter spacers on each long section of leather. Fold about 3/8 inch of the leather end over to form a loop and secure with a coil using the wire.
-
Repeat on the other side. Use the 6mm jump rings to attach each section of the toggle clasp to the leather loops.