Believe in Yourself Stamped Bracelet
"This bracelet can be made in less than one hour! Use 4mm Script font and 1.5mm Deco font to stamp a word or phrase that inspires you onto an Artisan pewter blank. Add beads, chain and a clasp, and it's ready to wear!"
Project TypeMake a Project
Bead TypeMetal, Pearl
Time to CompleteUnder an hour
Bead Technique UsedMetalwork
Bead Project TypeBracelet
Materials List
- Artisan Pewter Stamping Blank
- 7mm Jump Rings (4)
- Round Nose Pliers
- Chain Nose Pliers (2)
- Flush Cutters
- ImpressArt Script Letter Stamps
- ImpressArt Deco 1.5mm Uppercase Letter Stamps
- ImpressArt Ergo-Angle Hammer
- Steel Block
- Stamp Straight Tape
Instructions
-
Center the Stamp Straight Tape horizontally on the pewter blank.
-
Using the Script font, stamp the word of your choice on the blank, aligning the first letter with the left side of the blank. Align the bottom of the letter stamp with the top-line of the tape Using the Ergo-Angle hammer, strike the stamp with medium force at a 90 degree angle
-
Place the Stamp Straight Tape approximately 3mm below the script word.
-
Using the Deco font, stamp the remainder of the phrase on the blank, aligning the last letter with the right side of the blank side of the blank.
-
Stamp the remainder of the phrase from right to left.
-
Highlight the stamped word with stamp enamel Use the Q-tip to ensure the enamel completely covers the impression Wait 10-20 seconds Blot with a soft cloth Wipe away the excess stamp enamel with a soft cloth