Boho Mixed Bead Kumihimo Bracelet
Boho Mixed Bead Kumihimo Bracelet
If you're bored with basic kumihimo patterns, try mixing it up with the Boho Mixed Bead Kumihimo Bracelet. Once you've learned how to kumihimo braid with beads, experimenting with different bead combinations seems like the natural next step. The assortment of wood, turquoise, and faceted gold beads in this kumihimo bracelet pattern creates an earthy palette any boho-chic fashionista would love to wear. See what different bead combos you can come up with as you try this DIY bracelet tutorial.
Project TypeMake a Project
Bead TypeWood, Miscellaneous
Time to CompleteIn an evening
Bead Project TypeBracelet
Materials:
- #34745016- 19.7yd 1mm Rayon Cord- Metallic Gold
- #34750021- 28pc Metal Findings Mix- Gold
- #34745010- 5x3mm 300pc Wood Rondelle- Brown
- #34745011- 5x3mm 300pc Acrylic Rondelle- Turquoise
- #34745003- 6mm 300pc Acrylic Faceted Rondelle- Gold
- #34745033- 5 3/8 1pc Round Disk
- #34745035- 1pc 2in Eye Needle
- #34745036- 8pc Bobbin Pack
- #22279001- 1oz E6000 Glue
- Shayna Bracelet Project Sheet
- #4457- Side Cutter Pliers
Instructions:
-
Cut four 49-inch lengths of gold metallic cord.
-
Bring the cord ends together and fold in half. Bring the fold down through the center of the round disc.
-
Cut a scrap piece of cord (4+ inches) and tie it onto the center fold from step 2.
-
Align the cords as explained in the “Beaded Kumihimo” instruction booklet that came with the round disc.
-
Using the big eye beading needle, thread four wood, three gold, one teal, three wood, three gold, one wood, three teal, three gold, one wood, two gold, four teal, three gold, and three wood beads onto each strand.
*This makes an 8-inch bracelet with cord ends and lobster claw clasp. Use fewer or more beads on each of the eight cords to decrease or increase the overall length.
-
Wind each of the eight cords (with beads) onto a bobbin and close.
-
Follow the beaded instructions that came with the disc. Braid the cord 1/2 inch before adding the beads.
*This section will be inserted into the clasp.
-
Braid a 1/4-inch tail after all of the beads have been braided in. Remove the cords from the bobbins and from the disc and tie them into a single knot. Remove the scrap cord from the other end.
-
Trim the excess cord. Insert an eye pin into each end section of the braid so the pins face out the ends of the braid. Then apply glue to the ends of the cords and slide the cord ends on, threading the eye pin shaft through the hole.
-
Form a loop. Use 4mm jump rings to attach a lobster claw clasp to one end and a length of extender chain to the other end.
*Allow the glue to dry according to manufacturer instructions (2+ hours).