If you are looking for a beautiful DIY bracelet to make next, then this midnight Blue Iris Kumihimo Bracelet is perfect for you. With easy-to-follow instructions, this DIY jewelry tutorial teaches you how to make a bracelet by kumihimo braiding. Kumihimo patterns are elegant, intricate, and produce stunning jewelry pieces. If you want a bracelet that sparkles and shines with style, then this bracelet is for you. You will never want to take this chic and cool metallic bracelet off your wrists once you have made it.
Project TypeMake a Project
Bead TypeMiscellaneous
Time to CompleteIn an evening
Bead Project TypeBracelet
Materials List
- Round Nose Pliers
- Needle Nose Pliers
- Wire Cutters
- Metallic Blue Cord (x1)
- Kumihimo Bobbins (x1)
- Metallic Blue Rondelles (x1)
- Kumihimo Round Disc (x1)
- Silver Kumihimo Findings Pack (x1)
- Kumihimo Beading Needle (x1)
- E6000® Glue (x1)
Want more kumihimo? Take a look at this comprehensive collection of kumihimo projects. From 8-cord kumihimo patterns to 12-cord kumihimo patterns, from beaded and embellished kumihimo to simple cord kumihimo, from round kumihimo braiding to flat kumihimo braiding, this collection of kumihimo patterns and tutorials covers it all.
Blue Iris Kumihimo Bracelet
Prima Bead Bracelet Instructions
-
Cut (4) 50” lengths of blue metallic cord.
-
Bring the cord ends together and fold in half. Bring the fold down through the center of the round disc.
-
Cut a scrap piece of cord (4+ inches) and tie it onto the center fold from step 2.
-
Align the cords as explained in the “Beaded Kumihimo” instruction booklet that came with the round disc
-
Using the big eye beading needle, thread (30) metallic beads onto each strand. This makes an 8” bracelet with cord ends. Use less or more beads on each of the eight cords to decrease or increase the overall length.
-
Wind each of the eight cords (with beads) onto a bobbin and close.
-
Follow the beaded instructions that came with the disc. Braid the cord 1/2” before adding the beads. This section will be inserted into the clasp.
-
Braid a 1/4” tail after all of the beads have been braided in. Remove the cords from the bobbins and from the disc and tie them into a tight single knot. Remove the scrap cord from the other end.
-
Trim the excess cord. Next apply glue to the ends of the cords and slide the cord ends on. Allow the glue to dry according to manufacturer instructions (2+ hours).